How remove the cartridges on Epson Stylus TX130

Learn here how to remove the cartridges in the printer Epson Stylus TX130 from the beginning to the end.

This type of printer uses individual ink cartridges Epson, these cartridges allows us to replace the spent cartridge just as each color separately and do not have integrated printhead cartridges.

Normally when a printer is about to spend a cartridge it warns, and proceed to take away, it is a simple process but if you have not done before can be difficult.
Below we present how to get the ink cartridges and replace in the Epson Stylus TX130 printer, follow the steps as described and if you have any questions please comment.

We recommend installing new cartridges immediately and not leave the printer without cartridges, this can dry the ink remaining in the head and cover, next is to damage the head and no solution or at least is not easy.

If an empty ink cartridge in the printer or is about to run out of ink indicators begin to flash. It is possible that the printer software we estimated that an amount of ink in each cartridge, so that from now on the process becomes easier.

First thing we do is open the scanner cover and open the cover below which gives access to the ink cartridges, the cartridge carriage will position these replacement cartridge that will replace the right place to remove.

If you have more than one cartridge to replace what we will do is press the cancel button and this will be in the place where it can be removed more easily.

epson printer cartridge change

As we can see the printer has a safety cover up the cartridges, this only gives us access to a single cartridge, this cover is not necessary to move when we raise the lid of the cartridges they will be on the left side of the printer where the we can see, to move a cartridge elsewhere have to follow the procedure of pressing the stop button.

The next thing is to get the cartridge is empty and put a new and full cartridge, the steps are simple tend to move a clip that has the cartridge in the back that allows the cartridge holding the printhead and then extract the cartridge up.

remove and replace cartridges

The next step is to take the new ink cartridge that will put in printer, unpack and put it in the printer, this new cartridge avoid as much as you can touch the connectors, and place it firmly into the printer, cartridge comes with a protective tape on the bottom where the ink nozzle needs to be broken.

putting ink cartridge

After being put ink cartridge in the printer pressed the stop button again, this makes cartridges are located inside the printer where it belongs, if you can send a test page after placing the cartridge.

If that does not work or has a mishap contact us through a comment on this same published.