How to install printer ink system for Epson Stylus TX125 | en.Rellenado

How to install printer ink system for Epson Stylus TX125

Advertisements
An ink system for Epson Stylus got it with ease on the Internet, these are usually manufactured in China and have a battery to reset itself cartridge on top.

Ink systems for these printers are good and have a good performance, they have no sponge inside and have considered such as the best in our publication best printers for continuous ink systems.
The process for installing an ink system on these printers is simple, we just replace the cartridges that brings this printer cartridges manufactured by adapting see steps below system.

Consider always put good quality ink and Epson printers, this way is the only way you can ensure proper system operation, if we put the ink that is not compatible with the heads of the printer immediately we give up on the printer.

How to install continuous ink system Epson Stylus TX125

To facilitate system installation it is recommended to remove from the front of the tray awaits the pages as they exit and lid that gives access to the cartridges, just force a little to the front the two covers and will have in their hands, know that just do this to facilitate access to the inside of the printer.
epson printer cartridges access
epson printer cartridges access
Thus it should be our printer, then turn on the printer and wait for the ink cartridges are positioned in the central part of the printer, just when the cartridges are passing through the center disconnect the printer.

This action only seeks not have the ink cartridges on the left side of the printer when the cartridges are at rest the car can not move, for installation of the system need to move the head freely from side to side.

We position the system on the right side of the printer and begin to enter the system to the printer, this I walked through the front of the printer to where they should go out ink cartridges, since it is only possible to put ink cartridges above, when we take the ink cartridges to be put where the next step is to put them. We check that has the battery you should have each ink system for reset.
enter Epson printer cartridge system
enter Epson printer cartridge system
The next step is to leave the system out of the printer ink but with the cable inside, entering through the front of the printer, as show below.
entering epson printer cartridges
entering epson printer cartridges
When the cartridges are out of the printer at the top move the printer carriage to the left side. This should be right where normal cartridges will proceed to put the ink system on the head. Ink system easily enters from the top, just where normal ink cartridges are replaced.

We positioning system hoses ink so do not get stuck inside the printer, for this we must use tools that brings the ink system, these are clip are double-sided tape.

When we put the cartridge into the printhead cartridges must strongly press down until you hear a sound like clip, with that look that chip ink system make the corresponding contact and no problems printing den like a cartridge is not recognized.

We worked verification as support hose, that is verified if no jams or spindle hoses, move from side to side head to posts cartridges. Remember to place the front covers of the printer, without these we may receive errors that the printer has access door open.

At the end of every turn on the printer, place the filters to protect the ink tanks and verify the operation, if the printer does not recognize the cartridges must reset them to do this we must use the embedded with the printer resetter. You may be interested in our publication as reset Epson printers with continuous ink system.

Advertisements

No comments:

Post a Comment