How to install a system of continuous ink in a printer HP Deskjet 3050 | en.Rellenado

How to install a system of continuous ink in a printer HP Deskjet 3050

Advertisements
This is another of the printers using HP 122cartridges, we have already done several publications both on how refilling the cartridges hp 122 black and cartridges hp 122 tricolor we also did a post on how to reset the HP 122 cartridges and the true secret of cartridges HP 122, we know that the proper functioning of a printer at the same time the smooth functioning of an ink system we install a printer depends on a 80% cartridges quality.

Although these are not the best cartridges a safe installation of an ink system in a printer that uses these cartridges will work if the procedure is done as below.
Note that the HP Deskjet 3050 printer is a fast and compact printer thanks to its various functions of scanning, copying and printing all in one printer makes a good team for home and office with little work.

1. The first thing we do is to place the ink inside the tanks, put ink on consecutive points depending on the location that corresponds to the cartridges, place these on the same way as they go into the printer and place the hose that with the movement cartridge only contacts the corner where cartridges do not rest or rather where it is not the cleaner cartridge.
position of the ink hoses
position of the ink hoses
As you can see in the picture above on the side where the ink system hoses accumulate, it's just where it is not the system that cleans the cartridges.

You need to put some clips to hold the cartridge at the top as shown in the picture.

Unlike other HP printers use a carriage that holds the cartridges at a considerable height, so we will need to place hoses from ink system as seen in the image with the help of the clips that hold the hoses. see image below...
clips position to hold the system
clips position to hold the system
We cannot forget about the ink cartridges, since to these ones you will have to put the nudges on your system before putting the hoses, when we have nudges positioned correctly and without air leaks then we do what we do when it is a cartridge bleeding to leave these connected without air leak and ink at rest.

Bleeding from a cartridge it is when we put the hose near either the hole in the cartridge or in this case the nudges ink system when the hose is close but not connected then supply air to the ink tanks, put the air just where the ink tanks take in air and when it comes to ink cartridges connect it and stop supplying air to ink tank.

Remember to seal the openings of the cartridges 122, preferably using a heat gun silicone for this function.

After you do the ink system configuration, on the right side of the printer by placing a clip to hold the ink system hose. see image below...
position of the continuous ink system
position of the continuous ink system
Always remember not to let the ink system runs until the end, if a system hose one day takes some air then do the bleeding as we have shown above, if you do not understand a step in this procedure type a comment this post.

Advertisements

No comments:

Post a Comment