How to drain pads Epson printers with continuous ink system | en.Rellenado

How to drain pads Epson printers with continuous ink system

Advertisements
Epson printers like any other inkjet printer, have pads to store the ink cartridges do not print or purge removed from the injectors.
The system Epson printers, in particular is a bit more complex, since a hose carrying the direct ink pads printing, these over time is necessary to reset the printer — can get any reset, using the search engine — the same time is an advantage, because it will connect the hose has a deposit.

We will need a container to put the ink, and some ink hoses out of the mouth leading to the pads to the recipient.

It can be used to connect the hose to the tank to an elbow pads for connecting hoses cartridges, you can know which is watching our publication system components continuous ink.
elbow pads to take up ink from tank
elbow pads to take up ink from tank
Easily get the hose leading from the print head to the ink tank, you only need to remove the right cover of the printer — you may have some knowledge related to technical printer — should also find ways on how to get the hoses outside in to the printer.
remove the right cover of the printer Epson
remove the right cover of the printer Epson
No matter what your printer, always on this side will get the hose carrying the waste ink to the ink tank can find additional information on the Internet on how to uncover your printer model.
enter epson printer hoses where possible
enter epson printer hoses where possible
As long as it's on the same side of the pads, you can enter the hose to the tank, while hose down between the much better printer.

Finally the end comes out of the printer must put in the warehouse, and that this attached to the printer, so you avoid a huge amount of ink on the floor of the house or office spill. view image...
drain pads Epson
drain pads Epson
Thus we can see when you have a lot of ink deposit and replace or clean it is important to know that the connection between the hose that leads to the pads and going to the warehouse there should be no air leak.

If you need some extra help just write a comment, gladly it is answered, it is possible that not all printers is the same method to remove the lid and see the hoses, if so just type a comment with your printer model.

Advertisements

1 comment:

  1. why is my printer cannot print after i reset the inkpad?

    ReplyDelete