How uncover the ink cartridges using glass cleaner | en.Rellenado

How uncover the ink cartridges using glass cleaner

Advertisements
We have already seen how open an ink cartridge, from placing it in a ultrasound machine — which do not consider very efficientto place the cartridge in water Maríawhich I consider more efficient than the previous one — it should be noted that these are points and technically the matter.
glass cleaner to unclog cartridges
glass cleaner to unclog cartridges
The components for the manufacture of glass cleaner or glass cleaner are: flavoring distilled water / isopropyl alcohol / ethoxyphenol / ammonia / color (the latter do not help unclog a cartridge).To say which are the components of clean glasses, I do not pretend that the manufacture, better buy it in any store, even small pots to sell not buy as much if not necessary, you can also take from that used in the home.

I put the ingredients so they can determine, according to their names but do not know much they can realize that they are all liquids in one way or another help the nozzles have a good flow of the liquid with which it is printed — ink pigmented either or water-based — then the procedure to unclog cartridges.

Before doing this procedure, it is recommended to spend the possibility of solving the problem by cleaning that gives the system or printer software, most manufacturers include controllers tool for cleaning injectors.

The ink cartridge must be filled, as the injection process to uncover using the printer program here we need the cartridge is full of ink, and we will try to finish with the same ink pass through the injector and clean.
clean liquid crystals placed in the injector
clean liquid crystals placed in the injector
We put the cartridge with the nozzles in the manner shown in the image, apply some clean liquid crystals and let rest a moment. Average 5 minutes, do not allow this to dry completely. Spent time with napkin carefully clean the cartridge avoid touching the connectors not be necessary for some spilled liquid.
make cleaning injectors
make cleaning injectors
As is shown in the image, with a napkin or some soft cloth, we clean the moisture leaving the liquid in the nozzles. If a little is needed shake the cartridge to the ink drop.
place in container with liquid cartridges
place in container with liquid cartridges
Finally extract the ink cartridge is inside, it is recommended to have an extractor, if not see how you can make it durable and pieces that are obtained easy.
remove the ink cartridge
remove the ink cartridge
After this I hope that the cartridge is functioning correctly you if they can not opt for placing the cleaning cartridge in bath water, try not to more. Another question or think that you need to add some information, just write a comment.

Advertisements

No comments:

Post a Comment